Run separate underground conduits for high-voltage power cables and low-voltage signal/network cables.
Once the cabinets are mechanically secured and wired, attach the glass or acrylic barrier wings.
The finished floor must be perfectly level within
Inspect the glass leaf clamping mechanisms for signs of loosening or friction wear. gunnebo speedstile fl installation manual
Once the cabinets are correctly positioned, they must be securely fastened to the concrete floor.
Carefully attach the glass/polycarbonate swing panels to the mechanism.
Check the status LEDs on the optical sensor array. All infrared beams should show a "Clear" status when the lane is unobstructed. Once the cabinets are correctly positioned, they must
Once powered, the SpeedStile FL requires software configuration to match the site's security needs.
Pre-install separate conduits for high-voltage power lines and low-voltage signal/communication cables to prevent Electromagnetic Interference (EMI). 2. Unboxing and Component Identification
Connect the reference between the access system and the speed gate board. All infrared beams should show a "Clear" status
is an automatic speed gate, characterized by its swing panels (glass or polycarbonate) that open quickly in the direction of traffic. Secure, high-throughput access control.
The primary strength of the Gunnebo Speedstile FL Installation Manual lies in its structural approach to site preparation. Unlike simpler security devices, optical turnstiles are integrated systems requiring harmony between the physical floor, the electrical infrastructure, and the logical flow of human traffic. The manual dedicates significant attention to the "pre-installation" phase, outlining specific requirements for cable routing, floor flatness, and drainage.