: The M Series boards are specifically designed to fit into existing CASI enclosures, requiring only a straightforward swap of the legacy boards with new Lenel hardware. Power Requirements : Operates on 12 or 24 VDC input power.
Connect a laptop directly to the board (if necessary) and navigate to the default IP address (typically 192.168.0.251, though DHCP may be used).
: Operates on 12 VDC @ 300mA, with dedicated inputs for cabinet tamper and AC power failure monitoring. Installation & Migration Process The migration to an LNL-3300-M5 is a straightforward hardware swap:
: Supports a maximum of 32 board addresses and can communicate with other M5/M3000 units via an external RS-485 port. lenel lnl3300m5 installation manual upd top
Set DIP switch 1 OFF, 2 ON, 3 OFF, and 4 OFF to enable the default configuration. Default IP Address: The panel defaults to 192.168.0.251 Computer Setup:
: Power on the unit and wait approximately 30 seconds for it to reboot. Browse to
Disconnect all AC and battery power from the legacy controller. : The M Series boards are specifically designed
The is a high-performance Intelligent System Controller (ISC) designed as a "plug-and-play" upgrade for legacy M5 Bridge enclosures. It provides a modern gateway for transitioning older Casi-Rusco systems to the OnGuard security management platform without requiring a complete rewiring of the facility.
: Features AES 128-bit encryption for host communications and supports up to 32,000 access levels.
To set up the controller for the first time, you typically access its built-in web configuration page : : Operates on 12 VDC @ 300mA, with
Observe the . A steady, rhythmic blink indicates that the board operating firmware is running successfully.
What specific are you upgrading to?