Media Converter In Cisco Packet Tracer Link Jun 2026

Use a cable to connect a switch or router's Ethernet port to the converter's RJ45 port.

Connect the RJ-45 port of the second Media Converter to the target switch, router, or terminal server at the remote site. ⚙️ Hardware Modules & Interface Rules

: Fiber links in Packet Tracer often default to specific speed and duplex settings. If the link stays down, hardcode both ends to match (e.g., speed 100 and duplex full via the CLI). media converter in cisco packet tracer link

If you need to connect multiple copper devices to a fiber uplink without routing overhead, using a modular switch is the most efficient method. The has fixed ports, so you must use the Cisco PT-SWITCH-EMPTY . Step-by-Step Implementation

enable configure terminal interface fastEthernet 0/0 ip address 192.168.1.2 255.255.255.0 no shutdown end Use a cable to connect a switch or

Click on → Config tab

[Switch A: Copper Port] <--- UTP Cable ---> [Media Converter 1] <=== Fiber Cable ===> [Media Converter 2] <--- UTP Cable ---> [Switch B: Copper Port] Follow this sequence to link your nodes together properly: 1. Connect Copper Side (LAN) If the link stays down, hardcode both ends to match (e

Use a Copper Straight-Through Cable to connect the Switch (e.g., FastEthernet 0/1) to the Media Converter's RJ45 port.