A level concrete floor is mandatory. The foundation must be flat, horizontal, and meet the minimum depth specifications (typically 150mm–200mm of reinforced concrete).
Leave a comment below with your DS2 model variant, and we will help you locate the correct manual section. Always follow local safety regulations when installing or repairing industrial remote control systems.
The is a classic electro-mechanical 2-post lift used in automotive workshops for lifting vehicles during maintenance and repair. As part of the heritage line from AUTOPSTENHOJ , the stenhoj ds2 manual
Positioned directly beneath or adjacent to the main nut, the safety nut travels freely without carrying a load. Checking the Wear Gap
Ten minutes passed. Then twenty.
If the main nut wears past a critical threshold, it drops onto the safety nut. This mechanically triggers a safety switch that cuts power to the lift, preventing it from raising any further until the nuts are replaced. 4. Routine Maintenance and Lubrication Protocols
: Safe operation starts with the floor. Per Stenhøj’s guidelines , the concrete must be a minimum of 200 mm thick with a compressive strength of at least 3000 psi . A level concrete floor is mandatory
Verify that the arm locks engage automatically when the arms are raised slightly off the ground. Loading the Vehicle Center the vehicle between the columns.
Proper site preparation ensures the safety and longevity of your lift. 1. Floor Requirements Reinforced concrete only. Thickness: Minimum 150 mm to 200 mm depth. Strength: Concrete must handle at least 3000 psi. Always follow local safety regulations when installing or
: Standard operation requires continuous pressure on the control buttons; releasing them stops all movement instantly. Essential Maintenance for Longevity