The system time should now read or 1970-01-01 . Try entering the corresponding default password (usually 123456 or 000000 ). Method B: Short-Circuiting the Reset Pins
If there is no external button, you may need to open the case.
Release the button or remove the screwdriver. The system will reboot into the initial setup wizard, allowing you to create a brand-new admin password. 5. Remove the CMOS Battery
With the power off and case open, locate these twin pads on the board. tronitek dvr admin password
If there is no button, look for two metal pins labeled "J1" or "TP" on the motherboard. With the power off, use tweezers to short (connect) these two pins, then turn the power on and hold for 10 seconds until it beeps. 3. CMOS Battery Removal
The first step in any lockout situation is to try the factory defaults. Tronitech rebrands firmware from several major SDK providers (often Hisilicon or similar). Therefore, depending on the age and model of your DVR, one of the following combinations will likely work.
Locate the silver, coin-shaped on the motherboard. The system time should now read or 1970-01-01
The exact of your Tronitek DVR (check the sticker underneath)
Power off, , and replace the casing. The password will be reset to default (blank or 123456). Securing Your Tronitek DVR
When prompted for credentials, try the following common combinations: admin | Password: (Leave completely blank) Username: admin | Password: admin Username: admin | Password: 123456 Username: admin | Password: 888888 Username: admin | Password: 000000 Username: admin | Password: 1234 Release the button or remove the screwdriver
The system clock should revert to a default year (like 2000 or 2010). Try the listed in Section 1. Method B: Shorting the Hard Reset Pins
Only attempt to reset or recover the admin password on a Tronitek DVR you own or have explicit permission to service. Unauthorized access is illegal under computer misuse laws.
